This section talks about using LCDproc with the serial LCD displays of the CFA632 and CFA634 series by CrystalFontz, Inc.
This driver must be compiled with SEAMLESS_HBARS option enabled. Otherwise horizontal bars will not display correctly. Use configure --enable-driver=CFontz --enable-seamless-hbars to accomplish this.
DEVICE
Select the serial output device to use.
If not given, default is /dev/lcd
.
WIDTH
x
HEIGHT
Set the LCD's dimensions in terms of characters per line and lines.
If not given, it defaults to 20x4
.
CONTRAST
Set the initial contrast.
Legal values for CONTRAST
are in the range
between 0
and 1000
.
If not given, it defaults to 560
.
BRIGHTNESS
Set the initial brightness.
Legal values for BRIGHTNESS
range from
0
to 1000
.
If not given, it defaults to 1000
.
BRIGHTNESS
Set the initial off-brightness.
This value is used when the display is normally
switched off in case LCDd is inactive.
Legal values BRIGHTNESS
are in the range
from 0
to 1000
.
The default is 0
.
1200
|
2400
|
9600
|
19200
|
115200
}
Set the the baud rate to use when communicating with the LCD.
It defaults to 9600
if not specified.
yes
|
no
}
Set the firmware version (New means >= 2.0) [default: no
; legal: yes
, no
].
yes
|
no
}
Reinitialize the LCD's BIOS [default: no
; legal: yes
, no
]
normally you shouldn't need this.